Can You Put 5th Gen 4runner Struts on a 3rd Gen 4runnet
Member
OP,
Did you measure the extended and compressed length of the rear socks?
is the 22" measured from hub centre?
Thanks!
[QUOTE=Acorn22;2700862]Hey guys thought I would mail service this incase anyone always had access to these interruption parts but weren't sure if they fit. Then I have a friend that just got Icon on his 2022 TRD Pro and he had no apply for his stock suspension, which means I could use whatever worked.
Starting time of all, the struts are wayyy too long and there is no possible way they would fit. Not certain about removing the bound and installing information technology into a shorter strut, maybe I'll effort that later.
The rear coils are colour coded pink/orange, nevertheless there is no indication of driver or passenger side that I could tell then I simply eyeballed it by which one was slightly taller. Also, these coils are thicker than OEM, and it has a slightly larger diameter of about 1/4", aught to screw anything up though. Because of this slight increase in bore the bumpstop cone kinda moves around upon install dissimilar in the OEM coil, merely it will still remain seated in the right spot once the install is done.
Every bit for the rear shocks, they are the Bilsteins with an external reservoir (part #: PTR13-89150-RR and PTR13-89150-LR). Yeah, they are near 3ish inches longer than stock break so if you're wheeling hard the coils volition fall out if you flex too much, and so I probably need to go some longer bumpstops or limit straps. The shock volition bolt right upwards to the factory brackets you may just take to compress the shock a little bit to get it on the lower stud.
Reservoirs are kinda abrasive me at the moment considering I need to come with a practiced way to mount them to the frame rail. They are currently clamped on and ziptied on to the frame lol
Take done no wheeling, but the rear finish is a lot firmer and less rowdy on the road. Takes speed bumps similar a fricken champ.
This lifted my 4runner about an inch in the rear, it used to sit slightly sagged, but at present it has just a slight rake in its stance (kinda hard to tell I think my photographic camera was slightly slanted...). 22" hub to fender on both sides with 265/75s.
Last edited by HiluxSurf SSR-G; 05-eighteen-2017 at 11:14 PM.
Source: https://www.toyota-4runner.org/3rd-gen-t4rs/238368-confirmed-5th-gen-trdp-rear-suspension-3rd-gen.html
0 Response to "Can You Put 5th Gen 4runner Struts on a 3rd Gen 4runnet"
Post a Comment